Start The Machine; Stop The Machine; Maintenance; Spray Tip Maintenance - GreenWorks ELITE EPW2000 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4.5

START THE MACHINE

CAUTION
Do not operate without the water supply connected.
CAUTION
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger to release air pressure.
3. If a stable stream of water come into view, release the
spray gun trigger.
1. Connect the machine to the power supply.
2. Set the power switch to the "ON" ( | ) position.
3. Turn the water supply on.
4. Pull the spray gun trigger.
4.6

STOP THE MACHINE

1. Release the spray gun trigger.
2. Press down on the ON/OFF switch, once again, to set the
power switch to the "OFF" (O) position.
WARNING
If you do not use the machine:
Stop the machine.
Turn the water supply off.
Disconnect the power cord from the outlet.
Pull the spray gun trigger to release the remaining
pressure from the machine.
Engage the trigger safety lock-out on the spray gun.
5

MAINTENANCE

WARNING
Before maintenance, make sure that you
Stop the machine.
Wait until all the moving parts stop.
Disconnect the plug from the power source.
English
Do not use strong solvents or detergents on the plastic
housing or components.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Replace the power cord by an approved service center.
5.1

SPRAY TIP MAINTENANCE

28
11
If there is too much pump pressure, the spray tip can become
clogged, you can feel a pulsing sensation while you pull the
spray gun trigger.
5.1.1
REMOVE THE SPRAY TIP
1. Pull back the quick-connect collar (27) on the spray wand
(4).
2. Remove the spray tip (11) from the spray wand (4).
5.1.2
CLEAN THE SPRAY TIP
1. Use a straight paper clip or cleaning tool (28) to clean the
spray tip.
2. Flush and clean the unwanted materials out of the spray
tip (11) with the garden hose (24).
3. Install the clean spray tip (11) to the spray wand (4).
6
TRANSPORTATION AND
STORAGE
Disconnect the power cord and watter supply hose before

transportation and storage.

11
WARNING
WARNING
WARNING
WARNING
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido