Transportation And Storage; Move The Machine; Store The Machine; Use The Nylon Velcro Tie Strap - GreenWorks GPW1804CK Manual Del Operador

EN
16 TRANSPORTATION AND
STORAGE
Disconnect the power cord and watter supply hose before

transportation and storage.

16.1

MOVE THE MACHINE

• Point the spray wand in a safe direction.
• Only hold the machine with the handgrip.
16.2

STORE THE MACHINE

Make sure that the spray gun, the uberflex hose and the
pump are dry.
Make sure the machine is out of the reach of children.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
• Disconnect the garden hose from machine.
• Wind the power cord and the uberflex hose.
• Clean housing and the plastic components with a moist
and soft cloth.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• If needed, call the customer service phone number
(enter number here) for servicing instructions.
• Store the machine in a dry, isolated and frost-free area.
16.3 USE THE NYLON VELCRO TIE
STRAP
1. Use one side of the strap (16) to tie the uberflex hose (7)
and the other side to up the power cord (8).
WARNING
WARNING
WARNING
NOTE
English
17

TROUBLESHOOTING

PROBLEM
The motor does
not start.
The machine does
not reach high
pressure.
10
POSSIBLE SOLUTION
CAUSE
The power button Set the power
is in the "OFF" switch to the
(O) position. "ON" ( | ) posi-
tion.
The power cord is Connect the power
not plugged in. cord to the power
supply.
Electrical outlet Try another elec-
does not supply trical outlet.
sufficient power.
The circuit breaker Let it cool, and
is tripped. start the machine
again.
The power switch Pull the spray gun
is on, but you do trigger.
not pull the spray
gun trigger.
The diameter of Replace with a 1"
garden hose is too (25 mm) or 5/8"
small. (16 mm) garden
hose.
Water supply is re- Check garden hose
stricted. for kinks, leaks,
and blockage.
The water supply Open the water
is not sufficient. supply fully.
Spray tip has not Install desired
be installed onto spray tip to end of
the spray wand wand.
properly.
The water intake Remove filter and
filter is clogged. rinse in warm wa-
ter.