Vetus WC12S2 Instrucciones De Instalación Y Manual De Manejo página 8

Inodoros marinos eléctricos
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
1 Introduction
The Vetus WC..S(2) and WC..L(2) toilets are marine toilets with
an integrated pump system. With correct installation and opera-
tion, these toilets function like a normal toilet.
These Vetus toilets may only be used for pumping and
removal of faeces and toilet paper.
These toilet are not suitable for pumping other objects
such as cotton wool pads, tampons, sanitary towels, con-
doms or hair, or for pumping out fluids like oil. This could
cause damage!
Always make sure you have a pair of rubber gloves on board.
2 Working
12 V / 24 V:
The particular cycle chosen is carried out
automatically after operating the appropri-
ate button.
A choice can be made between the
'ECO' cycle of about 10 seconds and the
'NORMAL' cycle that lasts about 20 sec-
onds.
120 V / 230 V:
When the button on the toilet pot is
pressed the cycle is carried out automati-
cally.
This lasts for about 25 seconds.
The cycle consists of:
• A flushing phase:
The magnetic valve allows water to run into the toilet for a set
time.
• A grinding / pumping phase:
The motor drives the knife blades and the pump. The faeces
and toilet paper are ground up and pumped away.
• A phase in which the water seal is brought back to the nor-
mal level:
The magnetic valve allows water to run into the toilet for a set
time. This forms a water seal and prevents smells in the toilet
pot.
3 Safety
Ensure that the power supply is switched off during mainte-
nance or repairs.
8
110123.02
Note!
4 Installation
4.1 Algemeen
See Page 26 for installation examples.
Always install the toilet in accordance with the applicable regu-
lations of the country concerned. In some areas, it may not be
permitted to pump waste straight from the toilet into the water!
4.2 Fitting the toilet to the floor
Always mount the toilet on a sufficiently strong floor to prevent
the occurrence of point loads and the toilet bowl splitting. If
necessary fit an extra sheet of multiplex under the floor to rein-
force it.
• Place the toilet in the position required.
• Determine the position of the fitting holes. Use the toilet as a
template for this.
• Attach the toilet using the fasteners supplied.
WCS(2)
WCL(2)
Electric marine toilets WCS(2) - WCL(2)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wc24s2Wc110sWc220sWc12l2Wc24l2Wc110l ... Mostrar todo

Tabla de contenido