Krups XP6180 Manual De Instrucciones página 11

KR_ESPRESSO_XP6180_NC00023127-03_Mise en page 1 09/03/12 09:50 Page11
NOTE: Before turning on the espresso machine ensure that the steam and hot water control dials are in
the OFF position (fig. 1 and 2). When the 'POWER' light flashes green, the machine is heating
up.
Place glasses and cups on the warming plate.
IMPORTANT: For first time use or if the machine has not been used for some time, it is important that the
machine is rinsed as follows:
Fill the tank with fresh water up to the maximum water level.
Fit either the single or double filter basket into the filter holder (fig. 7). Secure the filter holder to the group
head (fig. 8).
Place a sufficiently large container under both pouring spouts.
Start rinsing by circulating the full tank of fresh water as follows:
- 1/4 of the water tank through the SPOUT circuit: turn the hot water control dial anti-clockwise as far
as it will go until 1/4 of the water has been poured. Turn the dial clockwise to stop the pour.
- 3/4 of the water tank through the ESPRESSO circuit: press the 'MANUAL' button and let the water
to run through.
NOTE: The espresso machine is programmed to automatically stop the water flow after 240ml, press the
'MANUAL' button again to restart the water flow.
US I NG TH E CONTROL PAN E L"
Power
Press the "POWER" button once to turn the espresso machine on (fig.6). The light above the "POWER"
button will illuminate green and start flashing to indicate that your machine is on and heating up. When the
green light above the "POWER" button stops flashing and turns to a constant red light, this indicates that
the espresso machine is heated and ready to use.
ESPRESSO" and "DOUBLE ESPRESSO" buttons will show a constant green light. The machine is
now in Ready Mode.
NOTE: Remember that if the light above the "POWER" button is flashing it means the espresso machine is
adjusting the temperature of the heating system. To turn the espresso machine off, simply press the
"POWER" button, the red power light and all the other lights on the control panel will turn off.
Manual
The manual button allows the coffee maker to have complete control over the length of the espresso pour.
Once the espresso machine is switched on and heated, the light above the "POWER" button will turn red
and the lights above the "MANUAL", "SINGLE ESPRESSO" and "DOUBLE ESPRESSO" buttons will
show a constant green light, you can now use the machine in manual operation. Simply press the
"MANUAL" button once to start the pour and again to stop.
IMPORTANT: Once the manual mode operation is activated, before the espresso pour starts the pre-infusion
feature will release three short bursts of gradual water pressure onto the coffee cake. After
this the full water pressure is applied and the espresso will pour freely.
NOTE : When you activate the manual operation the lights above the "SINGLE ESPRESSO" and "DOUBLE
ESPRESSO" buttons will go off. The lights above the "POWER" and "MANUAL" buttons will remain
on.
Single espresso
The "SINGLE ESPRESSO" function removes the guesswork and is programmed to pour 1 ounce of liquid
espresso.
Tip: We recommend using the single cup filter when using the programmed single espresso operation.
The lights above the "MANUAL", "SINGLE
English
11