Environmental Protection - Würth ANG 310 Traducción Del Manual De Instrucciones De Servicio Original

Setting a rivet nut
Insert the screwed-on rivet nut into the rivet hole.
■
Keep the trigger [11] pressed til the setting
■
procedure is completed and the rivet nut is
screwed off.
If the rivet nut is not screwed off completely, you
■
can drive out the nut by turning the provided
wrench [8] in the hexagonal recess [7].
Changing the threaded mandrel/
sleeve (fig. II)
Screw in mounthpiece [2].
■
Press down the slide [14] completely.
■
Unscrew and change the sleeve [1] .
■
Align the sleeve [1] with the socket.
■
Lock the sleeve [1] by pulling the slide [14]
■
back to the end position.
Screw on the appropriate mouthpiece, ajust
■
the length x of the threaded mandrel and lock
the mouthpiece [2] against torsion using a lock
nut [3].
When changing the sleeve, the mouthpiece must
■
be screwed in right to the stop of the sleeve.
Maintenance / Care
Important
Remove the battery before working on
the device.
Device and battery do not require maintenance.
In the unlikely event of a failure or defect, have
the device repaired by a Würth masterService
workshop.
In all your queries and spare part orders, always
quote the product number (see type plate) of your
device.
The current spare part list of the device can be
viewed online at http://www.wuerth.com/partsman-
ager. Alternatively, contact your local Würth agency
for a hardcopy.

Environmental protection

Dispose of the power tools, accessories and pack-
aging material in an environmentally friendly man-
ner for recycling, where this is possible.
Only for EU countries:
Do not dispose of power tools with
domestic waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment (WEEE),
power tools must be collected sepa-
rately for recycling.
Batteries:
Do not dispose of batteries with domestic waste,
do not expose to fire or water. Collect and recy-
cle batteries or dispose of with due care for the
environment.
Only for EU countries:
Directive 2006/66/EC stipulates that defective or
worn batteries must be recycled.
In Germany, devices or batteries which are no
longer in working order can be returned to Würth
for recycling.
Warranty
This WÜRTH appliance is covered by warranty
according to the applicable national regulations.
The warranty period begins on the date of purchase
(please retain invoice or delivery note as proof of
purchase).
Faults covered by warranty shall be eliminated by
replacement or repair. Damage caused by improper
operation is not covered by warranty.
Claims can be recognised only if the device is in a
non-disassembled state and presented to a Würth
branch office, your Würth sales representative or a
customer service office authorized by Würth.
Technical changes reserved.
We accept no liability for printing errors.
15