Attention!
Risk of property damage
The pressure can also cause the product to
■
flow out and cause the device to stick strongly
together.
¾ Never completely shut the air regulator [2]
during use.
¾ Never completely unscrew the air regulator [2].
Combined setting
Combined setting of air vent regulator [WB] and air
regulator [2] allows a smooth or coarse surface to
be achieved as desired; and thus a finish matching
the original finish of the part being treated can be
achieved.
In these cases, the compressed-air reducer [WB] is
adjusted to match the requirements of the operator.
Maintenance / care
WARNING!
Risk of injuries or property damage
due to improper actions.
¾ Disconnect the device from the air
supply before carrying out any
service or maintenance work.
Empty detachable tank or remove bottle.
■
Pour a sufficient amount of a suitable thinner for
■
the product used into the empty detachable tank
or the bottle.
As necessary, position the bottle and tighten in a
■
clockwise direction.
Position the detachable tank and tighten in a
■
clockwise direction.
Connect the device to the air supply again.
■
Spray solvent into a special container until the
■
device is clean.
When doing so completely close the regulator,
to prevent atomising of the solvent, which
could result in contamination of the immediate
surroundings.
16
Note
Do not immerse the device completely
in the solvent; clean using a soft brush
or cloth.
Do not clean the components of the device using
■
wire brushes or sandpaper.
On no account should acids or alkaline
■
cleansing agents be used for cleaning.
If necessary lubricate the nozzle needle and air
■
vent rod.
Check the thread regularly for wear to ensure
■
parts such as the tank or adjustment wheel do
not unintentionally become loose.
After cleaning, maintenance and/or repair
■
work, check that all screws and nuts are securely
tightened.
Environmental instructions
Do not dispose of this device with
normal household waste. Dispose of
the device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Dispose of all packaging in
an environmentally compatible manner.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note).
Damage that has occurred will be corrected either
by replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims under warranty can only be accepted if
the device is returned fully assembled to a Würth
agency, your Würth sales representative or an
authorised Würth customer service workshop.
Subject to technical changes without prior notice.
We accept no liability for printing errors.