Bimar VC76 Folleto De Instrucciones página 12

(plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children
because they are potential sources of danger.
• Before connecting the appliance, check that the voltage values shown on the data plate
correspond to those of the electricity supply network. In the event of incompatibility
between the electric outlet and the plug of the appliance, have the outlet replaced with
another more suitable type by professionally qualified personnel, who will make sure that
the section of the wires of the outlet is appropriate for the absorbed power of the heater.
In general, the use of adapters or extension cords is not recommended; if their use is
indispensable, they must conform to existing safety standards and their current capacity
(amperes) must not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Before each use, check that the equipment is in good condition, and that the power cable
is not damaged: if in doubt consult a qualified professional.
• Place the appliance far from
Heat sources (e.g.flames, gas stoves etc.)
-
container of liquids (e.g.sinks etc) to avoid any spray or the appliance falling into
-
it (minimum distance of 2 meters)
fabrics (curtains, etc.) or unstable materials that could obstruct the air intake grille;
-
make sure that the front is free of unstable materials (dust, etc.).
• The surface on which the appliance is placed must be stable, level (otherwise the unit
may fall over) and smooth. Do not place the fan on shelves. Do not hang the unit on the
wall.
• This appliance is not intended to be operated by means of an external timer or a separate
remote control system, to avoid the risk of fire in case the device is covered or is
positioned incorrectly.
• Do not place the wall fan into the room to avoid the back-flow of gases from the open
flue of gas or other fuel-burning appliances (for duct and partition fans).
•
This device is NOT suitable to use it in an explosive environment (in the presence of
flammable substances such as gas, vapor, mist or dust, in atmospheric conditions when,
after ignition, the combustion is spread in the air).
• Do not connect to thermal control systems or a programmer or timer or other device that
can automatically turn on the unit, thus avoiding the risk of damage to people, animals
or property.
ASSEMBLY
Attention: the fan can only be used if complete with the support base (front and rear
shell).
Attention: always unplug the appliance before you assemble.
To assemble it, refer to figures.
12/36