Bimar VC76 Folleto De Instrucciones página 13

1. Unscrew the ring nut on counterclockwise bottom of the body, if the nut is screwed.
2. Couple the rear shell to the front. Plug the power cord through the hole,
secure the set by turning clockwise the ring nut.
3. Plug the power cord through the guidance of the shell.
USE
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer or a
competent qualified electrician or a person with similar qualifications, in order to avoid
any risk.
Your appliance is equipped with the following regulation elements, controlled by turn the
knobs on the keyboard located on the rear of the control panel.
Plug it in.
Timer: This appliance has a timer for automatic switching off at the end of the time set; to
set the time turn the timer knob clockwise to the position corresponding to the desired
operating time (0-120 min.); in order to operate the appliance in a continuous manner, and
to therefore exclude use of the timer, turn the knob anticlockwise to the "ON" position.
Ventilation
After setting the timer:
To switch the appliance on, turn the selector knob to the position
-
corresponding to the desired power setting "1-2-3" (see a ref. picture on the
side)
0 = Off 1 = Speed minimum 2 = Speed medium 3 = Speed maximum
To activate oscillation (right-left) turn the knob clockwise to the position
-
corresponding to the desired power setting "1-2-3" (see a ref. picture on the
side).
To switch off the appliance, turn the selector knob to the "0" position or turn the timer
knob to the "OFF" position, and then remove the plug from the socket.
When not in use for long periods, the plug must always be removed from the socket.
13/36