Tabla de contenido
Publicidad
Completely immerse the right or left steam nozzle (6) into the
container with the liquid to be heated and push the steam
control lever (7) upwards.
Wait until the liquid has reached the desired temperature,
then lower the steam command lever (7) to stop the issue of
steam.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows: turn the
nozzle towards the cup tray and carefully activate steam
dispensing at least once.
General indications
Milk is a delicate biological product and can easily deteriorate.
temperature
container is opened and throughout its entire period of use.
Our storage appliances are suitable for this purpose.
NOTE: at the end of the work day (or not more than 24 hours
from the time the container is opened), any remaining milk
must be discarded.
Then plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for a
few seconds.
To enter the programming mode, press push button (18)
and keep it pressed for a few seconds; the buzzer sounds
intermittently.
To exit the programming mode, after programming the various
drinks, press push button (18) again.
" Before programming the coffee dispensing push
of ground coffee. Don't use coffee grouts for pro-
gramming servings."
unit, positioning the cup (or cups) under the nozzle (or nozzles)
10).
Press (and keep momentarily pressed) the coffee dispensing
push button (
or 20) corresponding to the required
serving to be programmed.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
Note: if you make a programming mistake, use a new dose of
ground coffee and repeat the operation.
from the moment the
10) on the coffee dispenser
7
6
When the required amount of froth has been made and the
turning knob (7) the other way (towards "0").
When the steam jet pipe (6) is no longer required, clean it
thoroughly with a sponge and a clean cloth.
Put a cup or other container under the hot water spout (8).
Lift lever (9) to dispense the desired amount of hot water.
Stop the dispensing by put lever (9) back into its original
position.
26
9
8
21
17
16
19
20
18
10
Publicidad
Tabla de contenido
