Control Panel; Basic Operation; Basic Use - Uline MINI PAK'R H-1604 Manual De Instrucciones

Length Control
Green LED
• Blinks on warm-up.
• Steady when ready.
Start Button
• Switch on to warm up
machine.
• Starts production of air
cushions.

BASIC USE

1. When machine is switched on, display shows "sty"
(Standby). (See Figure 7)
Figure 7
2. Mini Pak'r™ detects the film roll once it is
loaded.
3. Green LED on START button begins flashing.
Machine warms up.
4. Display shows the seal temperature during warm-up.
5. Once seal temperature is reached, green LED stops
flashing.
6. Display shows "rdy" (Ready). (See Figure 8)
Figure 8
PAGE 3 OF 21
(in feet)

CONTROL PANEL

START STOP/RESET
MINI PAK˙R
™
air cushion machine
(877) 594-5160
FP International
www.fpintl.com

BASIC OPERATION

7. Press START button to begin making air cushions.
(See Figure 9)
8. Air pump blows air into the film; after a few seconds,
the drive motor advances the air cushions through
the seal bar and slitting blade.
9. Finished air cushions emerge at front of
machine.
10. Press STOP/RESET button to stop production.
LED display
Set Air Fill Level
Set Seal Temperature
Red LED
Stop/Reset Button
• Stops air cushion production.
• Resets machine after an error is
adjusted.
Start
START STOP/RESET
MINI PAK˙R
air cushion machine
FP International
Figure 9
NOTE: Machine is preset to operate
continuously, producing air cushions until the
roll is empty. To create a fixed length of air
cushions, use the length control buttons.
(See Length Control, page 4)
Stop/Reset
™
(877) 594-5160
www.fpintl.com
0521 IH-1604