Uline MINI PAK'R H-1604 Manual De Instrucciones página 4

STANDBY
When out of use for 15 minutes, machines goes to
standby mode.
1. Display shows "sty." (See Figure 10)
2. Press the STOP/RESET button to resume air cushion
production. (See Figure 10)
3. Seal bar begins heating up.
4. Press the START button again when green LED stops
flashing and display reads "rdy." (See Figure 11)
NOTE: Machine automatically sets the correct
air and temperature settings for the film roll
loaded. There is no need to adjust the settings
manually. However, if needed, you can
change some settings with the control panel.
LENGTH CONTROL
Sets the length of air cushions to be produced each
time you press the START button.
• Continuous Mode: This is the factory preset. Press the
START button and machine runs the film until the roll
is empty or you press the STOP/RESET button. Display
will show the number of air cushions produced.
• Fixed Length: To produce a fixed length of air
cushions, press the (+) button until the desired length
shows in the display. The machine will count down
the length of air cushions yet to produce.
(See Figure 12)
• Change from Fixed to Continuous: Press the (–)
button until the display shows "---".
PAGE 4 OF 21
BASIC OPERATION CONTINUED
CHANGING MINI PAK'R™ SETTINGS
START STOP/RESET
MINI PAK˙R
air cushion machine
FP International
Figure 10
Start
START STOP/RESET
MINI PAK˙R
air cushion machine
FP International
Figure 11
START
MINI PAK˙R
FP International
Figure 12
Display
Stop/Reset
™
(877) 594-5160
www.fpintl.com
™
(877) 594-5160
www.fpintl.com
STOP/RESET
™
air cushion machine
(877) 594-5160
www.fpintl.com
0521 IH-1604