Seca 882 Manual De Instrucciones Y Garantía página 29

Limit value (seca 882 only)
The seca 882 personal scale is designed to check strain on people who have difficulty in
walking or on patients after surgery on the locomotor system. A weight limit value can be
set. When attempts at walking are made on the weighing platform, an acoustic alarm in-
dicates that the strain limit has been exceeded. This avoids excessive strain and allows
strain to be monitored and gradually increased. Applications include orthopaedic depart-
ments and physiotherapy practices
Three different weight limits can be stored.
– Press the Start key with no load on the
scale.
se(a 8. 8 . 8 . 8 . 8 .
,
secutively in the display. The scale is
then automatically set to zero and
ready for operation.
– Press the FUNC key.
The last function used appears in the
display.
– Use the arrow keys to select function
FU 2. Activate the limit value function
by pressing the FUNC key again
An arrow on the left-hand side of the
display indicates which memory is set.
– Use the arrow keys to select the de-
sired memory and press FUNC.
You will see the limit value from the
memory displayed.
– You can use the arrow keys to adjust
the value in increments according to
the graduations displayed.
– Once the correct value is set, press the
FUNC key again.
The limit value function and the alarm
signal are now activated.
– Step carefully onto the scale.
If the limit value entered is exceeded,
an alarm sounds.
– To switch off the scale, press the Start
key again.
Important note:
if the scale is switched off or switches off automatically, the limit value function
has to be reactivated by the method described above.
Model 882/pragma 883
0. 0 0
and appear con-
GB
29