YATO YT-82281 Manual Del Usuario página 12

GB
Cutting metal
Attention! Select an adequate blade for the metal to be cut. This will increase safety and prolong the life of the blade.
In case of cutting of thinner sheet metal, place it between two pieces of wood. This will permit to obtain a smooth cutting line and
reduce the vibration generated during work.
It is recommended to use an adequate cooling agent for the given metal. If possible, spread a thin oil fi lm within the area of oper-
ation of the foot of the saw. This will make operation of the saw easier.
Additional remarks
Avoid overloading the tool – the temperature of the external surfaces must not exceed 60oC.
Once the task has been concluded, turn the saw off , remove the plug of the tool from the mains socket and inspect the machine.
The declared total value of vibration has been determined by means of a standard measurement method and may be used to
compare the tool with another one. The declared total value of vibration may be used for an initial evaluation of exposure.
Attention! The vibration caused during work with the tool may diff er from the declared value, depending on the way in which the
tool is used.
Attention! It is required to determine safety measures to protect the operator, based on evaluation of exposure under actual cir-
cumstances of operation of the machine (including all the phases of the working cycle, for example the time when the tool is off
or is idling, and the activation time.
MAINTENANCE AND OVERHAUL
ATTENTION! Before any adjustment, technical service or maintenance operations unplug the tool. Once the operations have been
fi nished, the technical conditions of the tool must be assessed by means of external evaluation and inspection of the following
elements: body and handle, conductor with a plug and defl ection, functioning of the electric switch, patency of ventilation slots,
sparking of brushes, noise level of functioning of bearings and gears, start-up and smoothness of operation. During the guarantee
period, the user cannot dismantle the electric tools or change any sub-assemblies or elements, since it will cancel any guarantee
rights. All irregularities detected at overhaul or during functioning of the tools are a signal to have the tool repaired at a service
shop. Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.
O R I G I N A L I N S T R U C T I O N S
12