Intended Use; Operation; Changing The Battery Pack; Settings - Festool TSC 55 REB Manual De Instrucciones

[1-17] Viewing window / chipguard
[1-18] Splinterguard
5

Intended use

Cordless plunge-cut saws are designed for sawing
wood, materials similar to wood, plaster and ce-
ment-bonded fibre materials and plastics. When
fitted with special saw blades for aluminium of-
fered by Festool, the machines can also be used for
sawing aluminium.
Only saw blades with the following specifications
may be used: Saw blade diameter 160 mm, cutting
width 2,2 mm, location hole 20 mm, max. standard
blade thickness 1,8 mm, suitable for speeds up to
9500 rpm. Never use abrasive wheels in the ma-
chine.
The machine is designed and approved for use by
trained persons or specialists only.
Charger TCL 3 suitable for
– charging Festool battery packs: BP, BPS and
BPC (NiMH, NiCd, li-ion are recognised automat-
ically.)
– indoor use only.
The user is liable for improper or non-in-
tended use.
6

Operation

6.1

Changing the battery pack

Removing the battery pack [2 A]
Inserting the battery pack [2 B]
 Please note! Machine operation is only possible
under the following conditions [2 C]:
Both battery packs are used. Maximum
power with two battery packs (36 V).
Only the lower battery pack is used. Less
power with one battery pack (14.4 V/18 V).
6.2 Charging the battery pack [3]
 The battery pack is delivered partially charged.
Charge the battery pack completely before us-
ing for the first time.
The capacity display [1-12] automatically displays
the charge state of the battery pack [1-6] when the
ON/OFF switch is actuated:
70 - 100 %
40 - 70 %
15 - 40 %
< 15 %
Recommendation: Charge bat-
tery pack before further use.
LED red – lit continuously: bat-
tery, electronics or motor tem-
perature is outside the permitted
range.
LED red – flashing: indicates a
general fault, e.g. incomplete
contact, short circuit, battery
pack faulty, etc.
6.3 Festool charger
The LED [3-1] on the charger indicates the respec-
tive operating status of the charger.
Charger cable holder[3-2]
Unwind the cable completely from the recess
before using the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashes quickly
Battery pack is charged to maxi-
mum capacity.
LED green - flashes slowly
Battery pack is charged with
reduced current. Li-ion is
charged to 80 %.
LED green - lit continuously
Charging is complete or is not
restarted as current charge sta-
tus is greater than 80%.
LED red - flashes
General fault indication, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
LED red - lit continuously
Battery temperature is outside
the permitted range.
Wall mounting [4]
7

Settings

WARNING
Risk of injury, electric shock

Always disconnect the battery packs from the
machine before performing any type of work on
the machine!
TSC 55 REB
GB
21