Preliminary Settings; Single Patient Pre-Set Programs - I-Tech T-ONE REHAB Manual Del Usuario

In the INDIVIDUAL PATIENT mode, the active program is set an all 4 output
channels.
In the MULTI PATIENT mode, you can set two different programs (chosen
from the list of 22 programs) on the 4 channels: channels 1 and 2 will operate
on a program and channels 3 and 4 on the other program.
This function is particularly useful when you have to treat two patients in the
same session but also when you need to use two different programs on a
single patient, on two different areas of his body or for two different
disorders.
The function LAST 10 PROGRAMS allows you to quickly find the list of the last
10 programs used.
Confirm the selection by pressing

Preliminary settings

CONNECTING THE CABLES AND THE ELECTRODES
Place electrodes near the area to be treated (see next paragraph), connect
the electrodes to the connection cables and then connect the cables to the
outputs located on the bottom of T-ONE REHAB.

Single patient pre-set programs

To use the T-ONE REHAB pre-set programs, follow the instructions below.
1. SELECTING THE PROGRAM MODE
After choosing the SINGLE PATIENT mode, you must proceed to the
selection of the desired program, from the 6 groups of programs:
REHA, TENS, NEMS, MEM, BEAUTY, URO. Switch between groups
using the selection keys
program using the selection keys
by pressing
2. INTENSITY ADJUSTMENT
Use the coloured CH1/CH2/CH3/CH4 up arrow keys to increase the
current intensity on the 4 channels. The value changes by 1mA
IACER Srl
.
and
.
93
, and then select the desired
and ; confirm the selection
MNPG236-02