Overload Protection; Maintenance / Care - Würth ANG 14 Traducción Del Manual De Instrucciones De Servicio Original

If the battery is not inserted into the charger
■
during storage, do not forget to recharge the
battery from time to time.
If, despite recharging, the battery life is getting
■
significantly shorter, the battery is exhausted
and needs to be replaced.
Replacing the mouthpiece (fig. II – IV)
Remove the cover of the compartment for
■
mouthpieces [6] and select an appropriate
mouthpiece [2].
Note
Using mouthpieces of the wrong size
results in faulty riveting.
Remove the old mouthpiece [2].
■
Press the On/Off switch [8] while screwing
■
the mouthpiece [2] tightly into place using the
wrench [12].
Put mouthpieces which are not being used into
■
the compartment for mouthpieces [6] and close
the compartment with the cover.
Riveting
Insert the blind rivet into the mouthpiece [2].
■
Insert the blind rivet vertically into the hole for
■
the rivet and slightly press in.
Press the On/Off switch [8] and release again
■
when the rivet has been inserted.
In order to dispose of the riveting mandrel, tilt
■
the power tool towards the back so that the
riveting mandrel drops into the mandrel collector
or tilt it towards the front so that the riveting
mandrel falls out of the mouthpiece.
Empty the mandrel collector [5] regularly.
■

Overload protection

The power tool is equipped with an overload protec-
tion. In the event of an overload, the riveting proce-
dure is interrupted and the overload indicator [7]
is lit. Release the switch so that the power tool can
return to the initial position.

Maintenance / Care

Only the chuck mechanism and its wear parts
require maintenance.
Important
Remove the battery before working on
the device.
Remove the vice jaws from time to time, clean
■
them and lubricate the sliding surfaces.
In the unlikely event of a failure or defect, have
the device repaired by a Würth masterService
workshop.
In all your queries and spare part orders, always
quote the product number (see type plate) of your
device.
The current spare part list of the device can be
viewed online at http://www.wuerth.com/partsman-
ager. Alternatively, contact your local Würth agency
for a hardcopy.
13