Mounting; Electrical Installation - SICK GTE6V Instrucciones De Operación

4

MOUNTING

4 Mounting
5

Electrical installation

6
Optical axis, receiver
3
Optical axis, sender
4
Cable
5
LED indicator yellow: Status of received
6
light beam
LED indicator green: Supply voltage
7
active
Potentiometer: sensing range
8
Mount the sensor using a suitable mounting bracket (see the SICK range of acces‐
sories).
< 0.4 Nm
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established. The green LED indicator lights up on the sensor.
Explanations of the connection diagram (Tables 2 and 3):
Q / Q = switching outputs
n. c. = not connected
DC: 10... 30 V DC, see „Technical specifications", page 11
Table 1: DC
GTE6-
1
2
3
4
Optical axis, receiver
3
Optical axis, sender
4
Connector, M8
5
LED indicator yellow: Status of received
6
light beam
LED indicator green: Supply voltage
7
active
Potentiometer: sensing range
8
> 0 V) once all electrical connec‐
V
x24xxV x44xxV
+ (L+) + (L+)
Q
- (M) - (M)
Q
2
1= brn
1
2 = wht
3 = blu
4 = blk
0.14 mm 2
AWG26
= 0 V). The following informa‐
V
x74xxV
+ (L+)
Q Q
- (M)
Q Q
4 4
3
1
8021850 | SICK
Subject to change without notice
3
2