Mounting; Electrical Installation - SICK WTB4S-3 Manual De Instrucciones

5

Mounting

6

Electrical installation

8027693.1E52/2022-03-21 | SICK
Subject to change without notice
Mount the sensor using a suitable mounting bracket (see the SICK range of accesso‐
ries).
Figure 7: Alignment of the sensor relative to the object direction
Note the sensor's maximum permissible tightening torque of 0.8 Nm.
Note the preferred direction of the object relative to the sensor, cf.
page 17.
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Pin assignment
– Cable: Wire color
Only apply voltage and switch on the voltage supply once all electrical connections have
been established.
Explanation of the connection terminology used in the following tables:
BN = brown
WH = white
BU = blue
BK = black
n. c. = not connected
Q = digital output
L+ = supply voltage (U )
V
M = ground
MOUNTING
see figure 7,
O P E R A T I N G I N S T R U C T I O N S | WTB4S-3
5
en
17