Installing The Backrest - Invacare Aquatec Ocean Ergo Manual Del Usuario

Aquatec® Ocean Ergo / Ocean Ergo XL / Aquatec® Ocean 24" Ergo / Ocean 24" Ergo XL

4.2.2 Installing the backrest

1. Push down all four foot pedals of the castors to lock
them.
2. Push the backrest D from the rear side onto the seat
frame E, until the collar C touches the seat frame
tube F.
3. Position a washer B on each screw A and secure the
backrest on each side with a torque of 5 Nm using the
Allen key supplied.
IMPORTANT!
– Check the screws regularly to ensure they are
fastened securely.
Adjusting the backrest cover
The tension of the backrest cover can be adjusted as needed.
14
WARNING!
– Make sure that at least three belts are always
passed around the backrest frame (on the
outside) and their belt buckles are fastened.
Tightening:
1. Pull the belts A of the backrest cover tighter.
Loosening:
1. Open the buckles B by squeezing the retaining lugs
together (arrows).
2. Push the belts back a little through the buckle.
3. Fasten the belt buckles.
4. Retighten the belts gently.
1639501-C