Installing The Footrests - Invacare Aquatec Ocean Ergo Manual Del Usuario

Aquatec® Ocean Ergo / Ocean Ergo XL / Aquatec® Ocean 24" Ergo / Ocean 24" Ergo XL
9. Move the backrest cover so that the third belt runs
either above or below the armrest.
10. Pass the third belt of the backrest cover on the outside
of the backrest frame, close and tighten all belts.
11. The height adjustment procedure is the same for the
right and left armrest
To install accessories, the third belt from the top can
be opened and the backrest cover can be passed by
the backrest frame on the inside.

4.2.5 Installing the footrests

16
1. Insert the pin of the clip G from the outside into the
required hole on the footrest B. Make sure the clip
engages around the tube.
2. Push the footrest into the guide H at the front of the
side part until the pin of clip G engages in the groove
A. The footrest can no longer be turned to the side.
The assembly procedure is the same for the right
and the left footrest.
Adjusting the height of the footrests
The footrests can be shortened if required (refer to
the service manual). Shortening the footrests must
be performed by a qualified technician.
1. Slightly pull up the footrest B.
2. Pull the clip G out of the hole in the footrest and
re-insert it into the required hole. Pull out the footrest
slightly further if necessary.
3. Push down the footrest until the pin of clip G engages
in the groove A.
4. Set the other footrest to the required height as
described.
Adjusting the inclination of the foot plates
The inclination of the foot plates can be adjusted
infinitely variably.
1. Loosen the Allen screw C on the foot plate using a size
4 Allen key.
2. Turn the foot plate D to the required position.
3. Re-tighten the Allen screw.
1639501-C