Other Flash Options
Fixing the Irradiation Angle
Fixing the Irradiation Angle
Point the fl ash head at a wall or ceiling for
bounce fl ash photography. The area illuminated
at ranges of 0.6–1.0 m (2.0–3.3 ft.) will not be
correct; point the fl ash down.
1
Pressing the bounce lock release button,
turn the light-emitting section up/down and
left/right.
Using the Wide Panel
Using the Wide Panel
Use for angles of illumination wider than 12 mm (24 mm in 135 format). The
ZOOM display will blink if the lens focal length is under 12 mm.
1
Slide out the wide panel and place it on the
light-emitting area.
• The estimated range display changes when the
wide panel is used.
• Choose from angles of 10, 8, and 7 mm.
• Do not tilt the wide panel up.
• The ZOOM display will blink if the lens has a focal
length of 12 mm or more.
Using the Catch Light Plate
Using the Catch Light Plate
The catch light plate refl ects light from the fl ash to create a catch light effect.
1
Slide out the catch light plate.
2
Pressing the bounce lock release button, angle
the fl ash head straight up.
32
EN
90°
180°
MODE
0.0
TTL
RANGE
0.6~4.8
m
6°
180°
ZOOM
LED
A
A
10
OFF
mm