Protecting The Pump; Storing The Engine - Troy-Bilt 020210 Manual Del Propietário

PREPARING THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days,follow this
procedure:
I. Flush detergent siphoning tube by placing filter into a
pail of clean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2. Shut off engine and let it cool, then remove high
pressure and garden hoses.Disconnect spark plug wire
from spark plug.
3. Empty pump of liquidsby pulling engine recoil handle
about 6 times.This should remove most liquid in pump.
4. Use PumpSaverto prevent corrosion build up and
freezing of pump.
5. Store unit in a clean, dry area.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaverto treat pump.This
prevents freeze damage and lubricates pistons and seals.
NOTE: PumpSaver is availableas an optional accessory. It
is not included with the pressure washer.Contact the
nearest authorized service center to purchase PumpSaver.
To use PumpSaver, m ake sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructionsand warningsgiven on the PumpSaver
container.
CAUTION
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
CAUTION
Always wear eye protection when using PumpSaver.
NOTE: PumpSaverwill drip from pump after treatment
and will stain wood and concrete.
NOTE: If PumpSaveris not available,draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING THE ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
m