How To Use The Spraytips - Troy-Bilt 020210 Manual Del Propietário

Section 4: Operation
How to Use the SprayTips
The quick-connect on the nozzle extension allows you to
switch between five different spray tips.The spray tips vary
the spray pattern as shown below (Figure 9).
CAUTION
NEVER exchange spraytips without lockingthe safetylatch
on the trigger.
Follow these instructions to change spray tips:
I. Engagesafety latch on spray gun.
2. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in space provided on
handle storage panel.
3. Select desired spray tip:
For gentle rinse, select white 40 ° or green 25+
spray tip.
To scour surface, select yellow 15° or red 0 ° spray
tip.
To apply chemical, select black spray tip.
4. Pull back on collar, insert new spray tip and release
collar.Tug on spray tip to make sure it is securely in
place.
5. For most effective cleaning,keep spray tip from 8 to 24
inches away from cleaning surface. If you get spray tip
too close, you may damage cleaning surface. DO NOT
get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergentscould damage
the pump.
CAUTION
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
I. Review spray tip use.
2.
3.
Preparedetergent solution as required by manufacturer.
Place chemical injectionsiphon/fitter into detergent
container.
CAUTION
• When insertingthe filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
4. Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White, Green,Yellow, or Red).
Low Pressure \
Use to apply
chemical
Black White Green Yellow Red
40° 25° 15° 0°
High
Pressure
m