Dreame VTE1 Manual Del Usuario página 4

Product Overview
Accessories
Charger Extension Hose
2-in-1 Charging &
Storage Mount
(Including screws ×2, wall plugs
×2, mounting template sticker )
Extension Rod
Note: The illustrations in this manual are indicative only. The actual product may differ.
4
Crevice Nozzle 2-in-1 Brush Nozzle
Smart Multi-brush Bar Mini Electric Brush
Product Overview
Introduction of Display Screen
Note: If the vacuum cleaner cannot work normally, the display will show an error message.
Please refer to the troubleshooting part to find your solution.
Setting Language
Press and hold the button for 3 seconds to open the language list, then press the button
to scroll through the language to select the desired one. Press and hold the button
for 3 seconds to use the selected language.
Note: The display screen will turn to the main page if there is no operation for more than 15
seconds.
Switching Suction Level
Press the button to switch between three suction levels of eco, med/auto, and turbo.
The corresponding suction level will be highlighted on the display screen.
Only when using the smart multi-brush bar, the auto mode will be activated and the
notification of "Auto" will appear on the display screen. The vacuum cleaner will then
automatically switch the suction level between the floor/tile and the carpet.
Note:
• Stop the vacuum cleaner at any time while cleaning. Then it will continue to use the last
selected suction level when started again.
• Connecting the smart multi-brush bar to the vacuum cleaner will activate the Auto
Mode. In this mode, the vacuum cleaner can automatically adjust its suction level
depending on the surface type.
Electronic Lock/Reset Filter
• Press briefly to enter/exit lock
• Press and hold for 1.5 seconds to
enter the filter reset interface
Lock Status
Suction Level Status
Switching Suction Level
• Press briefly to switch the suction
levels
5