Shure T Serie Manual De Instrucciones página 13

Ocultar thumbs Ver también para T Serie:
Tabla de contenido

Publicidad

System and Component Specifi cations
RF Carrier Frequency Range
169.445 to 240.000 MHz (Available frequencies depend on
applicable regulations in country where system is used).
Operating Range: 100 m (328 ft.) under typical conditions
Audio Frequency Response: 50 to 15,000 Hz, ±3 dB
Image Rejection: 60 dB typical
Spurious Rejection: > 60 dB typical
System Distortion (ref. ±15 kHz deviation, 1 kHz modulation):
0.1% THD typical
Signal/Noise Ratio: 101 dB
Sensitivity: -109 dBm for 12 dB SINAD typical
Operating Temperature Range:
-18° to 57° C (0° to 135° F) NOTE: Battery characteristics may
limit this range.
Battery Life: 18 hours with 9 V alkaline battery (Duracell MN1604
recommended).
T1, T1G AND T11 BODYPACK TRANSMITTER
RF Output
50 mW typical (T1, T1G); 20 mW typical (T11)
Input Configuration
Unbalanced
Connector Type
1/4 Inch (T1G); 4–pin Miniature Connector (male)
(T1, T11)
Actual Impedance
1 MΩ
Maximum
+3 dBV
Recommended Input
Level*
Minimum
-80 dBV
Recommended Input
Level**
Connector Pin
Pin 1: Tied to Ground
Assignments (T1,
Pin 2: Tied to +5 V
T11)
Pin 3: Tied to Audio
Pin 4: Tied to 20kΩ Resistor and Audio Ground
Connector Pin
Sleeve: Tied to Ground
Assignments (T1G)
Tip: Tied to Audio
Dimensions
64 mm H x 106 mm W x 24 mm D
(T1, T1G)
Dimensions (T11)
83 mm H x 64 mm W x 26 mm D
Net Weight (T1,T1G)
96.4 g (3.4 oz.)
Net Weight (T11)
79.4 g (2.8 oz.)
Power Requirements
9 V alkaline battery (Duracell MN1604
recommended);
Nominal Current
30 mA
Drain
* Gain Control at minimum
** Gain Control at maximum
(2.52" H x 4.17" W x 0.95" D)
(3.27" H x 2.50" W x 1.03" D)
8.4 V NiCd battery optional.
T2 HAND–HELD TRANSMITTER
T2/58(SM58
RF Output
50 mW Typical (FCC); 20 mW Typical (ETSI)
Dimensions
236 mm H x 51 mm D
(9.29" H x 2.01" D)
Net Weight
295 g (10.4 oz.)
Power Requirement
9 V alkaline battery (Duracell MN1604
recommended); 8.4 V NiCd battery optional.
Nominal Current
30 mA
Drain
T3 RECEIVER
Connector
1/4" Phone Jack
Maximum Output
-6.8 dBV
Levels
Nominal Output
-32 dBV
Levels
Output
Unbalanced
Configuration
Actual Impedance
1 KΩ
Connector Pin
Tip: hot; Sleeve: ground
Assignments
Dimensions
35 mm H x 152 mm W x 98 mm D
(1.38"H x 5.98" W x 3.85" D)
Net Weight
192 g (6.8 oz.)
Power Requirements
12-18 VDC nominal, 200mA
Power Supply
120 V or 230V AC adaptor with 2.1 mm female plug
Voltage/Current/
Yes
Phantom Power
Protection
12
)
T2/(PG58
)
222 mm H x 51 mm D
(8.74" H x 2.01" D)
266 g (9.4 oz.)
30 mA

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

T3T2T1T1gT11

Tabla de contenido