Marshall MG Serie Manual Del Usuario página 3

MG10
1 2 3
MG15 & MG15R
1 2
1. Input Jack Socket
Jack input for your guitar. Use a good quality guitar cable
(i.e. one that's screened/shielded) to help prevent noise,
interference and unwanted feedback.
2. Volume Control - Clean Channel
This control adjusts the volume of the Clean Channel.
3. Channel Switch
This switch allows you to change between the amp's two
channels, Clean and Overdrive, via the front panel. When
the LED is green, the Clean channel is engaged. When
the LED is red, the Overdrive channel is engaged.
4. Gain Control - Overdrive Channel
This control sets the operating level of the pre-amp.
Simply turn up the Gain control until the required amount
of distortion is achieved.
5. Volume Control - Overdrive Channel
This control adjusts the volume of the Overdrive channel.
The louder this channel is set, the 'looser' the amplifier
will sound and feel.
6. Contour Control (MG10 only)
This highly effective tone control works by modifying the
mid-range (body). The tone can range from traditional
and woody sounding (setting at 10), to balls-to-the-wall
(setting at midway), to aggressive, 'scooped' and modern
(setting at 0)... and all points in-between.
7. Bass Control (MG15 & MG15R only)
Turning the Bass control will effect the amount of low
frequencies or bottom end in your guitar tone. Rotating
this clockwise will increase the amount of lower tones
creating deeper and thicker sounds. Turning this control
anti-clockwise will decrease the bass frequencies in your
tone reducing any bottom end thud.
8. Middle Control (MG15 & MG15R only)
Adjusting the middle frequencies will vary the amount of
body to your sound. Attenuating (decreasing) the middle
by turning this control anticlockwise will yield a more
hollow sound with the bass and treble frequencies
appearing to be more accentuated. Conversely,
increasing the middle will add body to the sound.
4 5 6
3 4 5 7
11 12 13
8 9 10
9. Treble Control (MG15 & MG15R only)
By adjusting the Treble control you can add or take away
the higher frequencies in your guitar tone. By increasing
the amount of treble you will make your tone brighter,
ideal for more percussive playing styles.
10. Reverb Control (MG15R only)
This control lets you add a lush reverb to the selected
channel, from a subtle hint to cavernous and all points
in-between.
11. MP3 Line In Socket
If you want to jam to your favourite MP3, CD or tape
track, merely connect the line out or headphone output of
your player here, adjust the volume of your player to
match that of your guitar and you've got the perfect 'play-
along' practice system.
12. Headphones Socket
For use when silent practice is the order of the day.
Connection of headphones will automatically mute the
internal speaker.
13. Power Switch
The power switch turns your amplifier on and off. The
Channel switch will light up when your amplifier is turned
on and will not be lit when the amplifier is switched off.
Note: The specific mains input voltage rating that your
amplifier has been built for is shown on the back panel.
Before connecting to the mains electricity supply, always
ensure that your amplifier is compatible with your
electricity supply. If you have any doubt, please get
advice from a qualified technician. Your Marshall dealer
will help you in this respect.
Please ensure the amplifier is switched off and
unplugged from the mains electricity supply before being
moved.
1
Technical Specification
MG10 MG15 MG15R
Power (RMS) 10W 15W
Channels 2 2
Speaker 1x6½" 1x8"
Weight (kg) 4.8 7.4
Size (mm)
W 296 382
H 314 379
D 175 205
11 12 13
15W
2
1x8"
7.4
382
379
205