Würth BS 13-SEC POWER Traducción Del Manual De Instrucciones De Servicio Original página 10

OBJ_BUCH-0000000133-002.book Page 10 Thursday, June 23, 2016 12:08 PM
Product Features
1 Keyless drill chuck
2 Spanner flats
3 Spindle collar
4 Venting slots
5 Rotation selector switch
6 Lock-on button
7 Torque-Control thumbwheel
8 Lock for mains cable module
9 On/Off switch
10 Thumbwheel for speed adjustment
11 Auxiliary handle
Not all of the accessories illustrated or described
are included as standard delivery.
Intended Use
The drill/driver is intended for drilling wood, metal,
and plastic, and for driving screws in and out.
For damage caused by usage other than intended, the
user is responsible.
Tool Specifications
Drill/driver
Article number
Rated power input
Output
No-load speed
Rated speed
Drilling diameter, max.
Steel
Wood
Max. screw Ø, wood
Max. screw Ø, aluminium
Spindle thread
Collar diameter
Chuck clamping width
Weight according to
EPTA-Procedure 01
Protection class
Removing the Drill Chuck
Loosen the drill chuck as shown, using two open-end
spanners and then unscrew the drill chuck.
Assembly is carried out in reverse order disassembly
(as shown in the figures).
Mounting an Application Tool
 Before any work on the machine itself,
pull the mains plug.
Inserting an Application Tool
Firmly hold the rear sleeve of the keyless drill chuck 1
and turn the front sleeve open until the application tool
can be inserted.
Clamping an Application Tool
(see figure B)
Hold the rear sleeve and firmly tighten the front sleeve,
turning it by hand. The audible locking action (click)
automatically locks the drill chuck.
To remove the application tool, the lock is automati-
cally released by turning the front sleeve in the oppo-
site direction.
BS 13-SEC
POWER
0702 315 X
Observe the mains voltage! The voltage of the
power source must correspond with the data on the
1200 W
type plate of the machine.
640 W
70 – 530 rpm
Mounting the Auxiliary Handle and
530 rpm
the Mains Cable Module
Fasten the auxiliary handle 11 to the spindle collar 3.
16 mm
The drilling depth can be set with the integrated depth
70 mm
stop.
12 mm
High reaction torque can occur with large drill bit diam-
8 mm
eters. For this case, the auxiliary handle provides addi-
tional safety.
1/2" x 20 UNF
43 mm
Connect the mains cable module to the handle. The
plug must engage.
13 mm
Switching On and Off
2.7 kg
Switching on without lock-on function:
II/
Press the On/Off switch 9 to start the machine.
To switch off the machine, release the On/Off switch
9.
(see figure A)
Starting-up
10