Intended Use; Product Features; Product Description And Specifications - Würth EMS 18-A EC SL Traducción Del Manual De Instrucciones De Servicio Original

OBJ_BUCH-3221-001.book Page 15 Friday, July 7, 2017 9:23 AM
 When working with the machine, always hold
it firmly with both hands and provide for a
secure stance. The power tool is guided more secure
with both hands.
 Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than by
hand.
 Keep your workplace clean. Blends of materials
are particularly dangerous. Dust from light alloys can burn
or explode.
 Do not open the battery. Danger of short-circuiting.
Protect the battery against heat, e.g.,
against continuous intense sunlight, fire,
water, and moisture. Danger of explosion.
 In case of damage and improper use of the
battery, vapours may be emitted. Ventilate
the area and seek medical help in case of com-
plaints. The vapours can irritate the respiratory system.
 Use the battery only in conjunction with your
Würth power tool. This measure alone protects the
battery against dangerous overload.
 The battery can be damaged by pointed
objects such as nails or screwdrivers or by
force applied externally. An internal short circuit
can occur and the battery can burn, smoke, explode or
overheat.
 Wear protective gloves when changing appli-
cation tools/accessories. Application tools/acces-
sories become hot after prolonged usage.
 Do not scrape wetted materials (e.g. wall-
paper) or on moist surfaces. Penetration of water
into the machine increases the risk of an electric shock.
 Do not treat the surface to be worked with sol-
vent-containing fluids. Materials being warmed up
by the scraping can cause toxic vapours to develop.
 Exercise extreme caution when handling the
scraper. The accessory is very sharp; danger of injury.
 Use only original Würth accessories.

Product Description and Specifications

Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fire
and/or serious injury.
While reading the operating instructions, unfold the graphics
page for the machine and leave it open.

Intended Use

The machine is intended for sawing and cutting wooden mate-
rials, plastic, gypsum, non-ferrous metals and fastening ele-
ments (e.g. nails, staples). It is also suitable for dry sanding
and scraping of small surfaces. It is especially suitable for
working close to edges and for flush cutting.
The light of this power tool is intended to illuminate the power
tool's direct area of working operation and is not suitable for
household room illumination.
For damage caused by usage other than intended, the user is
responsible.

Product Features

While reading the operating instructions, unfold the graphics
page for the machine and leave it open.
The numbering of the product features refers to the illustration
of the power tool on the graphics page.
1 On/Off switch
2 Venting slots
3 Battery unlocking button
4 Battery pack
5 Thumbwheel for orbit frequency preselection
6 Battery charge-control indicator
7 Button for charge-control indicator
8 SDS lever for releasing the application tool
9 Tool holder
10 Worklight
11 Plunge saw blade
12 Sanding plate
13 Sanding sheet
14 Handle (insulated gripping surface)
15