Technical Data; Noise/Vibration Information - Würth MSF 40 Traducción Del Manual De Instrucciones De Servicio Original

Intended use
The device is solely intended for cutting or chasing/
slotting of materials of primarily mineral content
(without the use of water), typical of which are
reinforced concrete, masonry and paving. Use only
original Würth accessories. Any other use or use
beyond this scope is considered improper use.
The user is responsible for damage result-
ing from improper use.

Technical data

Art.
Rated input power
Power output
Idle speed
Weight without mains lead kg
Diameter of the diamond
cut-off wheel
Possible slot widths
Adjustable cutting depth

Noise/vibration information

The noise level may exceed 80 dB (A)
during work.
Risk of severe injuries and acoustic
Â
trauma.
Wear hearing protection.
¾
Emission values
These values enable the estimating of the noise
emissions of the power tool and comparison with
various power tools. Dependent on the conditions
of use, state of the power tool or attachments, the
actual loading may be greater or smaller. When
estimating also take into consideration work breaks
and phases with lower loading. Specify protective or
organisational measures for the user based on the
appropriately adjusted estimation values.
20
0702 416 X
W 1,900
W 1,120
min 5,000
4.6
mm 125
mm 9.0 / 15.5 /
22.0 / 28.5 /
35.0
mm 10 - 40
WARNING!
Art.
a /K *
h h
L /K
pA pA
L /K
WA WA
Vibration total value (vector sum in three directions)
measured in accordance with EN 60745:
a = Vibration emissions
h
K = Uncertainty (vibration)
h
Typical A-rated sound pressure level:
L = Sound pressure level
pA
L = Sound power level
WA
K /K = Uncertainty
pA WA
* The specified vibration emission values:
• Were measured using a standardised test method
and can be used to compare one electric tool
with another.
• Can be used for a rough assessment of the
exposure.
Device elements
Overview (fig. I/III)
1 Clamping lever for cutting depth adjustment
2 Locking device
3 Trigger switch
4 Scale for cutting depth
5 Second handle
6 Electronic signal display
7 Marking (serves as cut indicator of the first
diamond wheel)
8 First handle
9 Spindle locking knob
10 Suction nozzle for dust extraction
11 Push direction arrow
12 Support wheels
13 2-hole-spanner
14 Markings of the cutting edges of the diamond
cut-off wheels
15 Protective guard
16 Arrows showing the direction of rotation of the
diamond cut-off wheels
17 Clamping nut
18 Diamond cut-off wheel
19 Clamping flange
20 Distance ring
*Accessories: not in scope of delivery
0702 416 X
m/s 5.5/1.5
2
93/3
dB (A)
104/3
dB (A)