Descargar Imprimir esta página

Remington PG6030 Manual Del Usuario página 3

Ocultar thumbs Ver también para PG6030:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
ENGLISH
C GETTING STARTED
,Charging your groomer
• Before using your groomer for the first time, charge for
14-16 hours.
• Make sure the product is turned off
• Place your groomer into the stand, connect the adaptor to
the product and then to the mains. The charging indicator
will light up.
Your appliance cannot be overcharged. However if the
product is not going to be used for an extended period of
time (2-3 months), unplug it from the mains and store. Fully
recharge your appliance when you would like to use it again.
To preserve battery life, let them run out every 6 months then
recharge for 14-16 hours.
FHOW TO USE
,Attaching and removing guide combs
• With the trimmer blade facing away from you, slide the
guide comb over the back of the trimmer blade and click
into position.
• With the trimmer blade facing away from you, carefully
push the guide comb away from the wide head trimmer.
Before you begin
,
Comb facial hair with a fine comb before you start trimming.
Hairs should be dry and without any waxes or lotions before
using the groomer
4
ENGLISH
,To thin and taper beards or moustache
• Attach the wide trimmer blade.
• Place the hair length attachment on the trimmer blade,
select the desired length and switch on.
• Start trimming under the chin, following the jawbone line.
Work toward the ear and upper beard line using an upward
motion.
,To trim edge of beard or moustache
• Attach the detail trimmer blade.
• Hold groomer with cutting blade facing you.
• Start with edge of beard/moustache line, and with the
cutting blades resting lightly against your skin, use slow
movements to create a beard/moustache line.
,To trim sideburns
• Hold groomer with cutting blade facing you.
• Use a small comb to lift the hairs. Hold the comb at the
desired beard or moustache length.
• Move the groomer along the comb to cut the hairs. Use light
pressure and well-controlled movements to trim hair.
,Trimming the nape of your neck
• Attach the wide trimmer blade.
• Use your fingers to lift the hair at the base of your head up
off the neck. Your index finger should be covering the roots
of the hairs you are lifting to prevent accidental removal by
groomer.
• Using your other hand, hold the groomer to the base of your
neck with the cutting unit facing up, and move the groomer
up the length of the neck until the unit touches your finger
5

Publicidad

loading