INTRODUCTION
Product Description
This submersible pump is for use in basins and is suitable for pumping clear water with up to 3/8" (9.5 mm)
spherical semi-solids. Do not use the pump in applications where effluent gray water or sewage or any
other debris (gravel, sand, floating debris, etc.), abrasives, or corrosives are present. Discharge height and/
or piping restrictions will reduce the pump's flowrate. Refer to the information in the tables below to con-
firm that this pump's performance is suitable for the specific application.
This product has been carefully tested, inspected, and packaged to ensure safe delivery and operation.
Please examine your item(s) carefully to ensure that no damage occurred during shipment. If damage has
occurred, please contact the place of purchase. They will assist you in replacement or repair, if required.
The pump motor is equipped with an automatic resetting thermal protector and may restart unexpectedly.
Protector tripping is an indication of motor overloading/overheating, which can be caused by application
issues such as an obstructed pump impeller, switch stuck in the ON position, pump running dry, pump air-
locked, pump short cycling, excessively high or low voltage supply, or possibly a pump, motor, bearings or
seal that have reached the end of their useful life.
This product is covered by a Limited Warranty for a period of 36 months from the date of original purchase
by the consumer. For complete warranty information, refer to www.littlegiant.com.
Specifications
Model
HP
5.5-ASPA
1/4
Model
5.5-ASPA
Model
5.5-ASPA
Integral Snap-Action Float
Volts
Hz
FLA
115
60
3.5
Gallons/Liters per Minute, at Height
5 ft
10 ft
1.5 m
3 m
35 GPM
30 GPM
132 LPM
114 LPM
Switch Type
15 cm - 23 cm
Amps
Watts
Start
8.8
360
15 ft
Feet
4.5 m
Meters
20 GPM
25 feet
7.6 meters
76 LPM
ON Level
OFF Level
6" - 9"
2" - 5"
5 cm - 13 cm
Product Description
Shut Off
PSI
10.8
0.745 bar
Maximum Water
Temperature
120 °F
49 °C
INTRODUCTION
3