Hilti SID 8-A18 Manual De Instrucciones Original página 12

▶ Before beginning the work, check the hazard classification of the
dust that will be produced. Use an industrial vacuum cleaner with
an officially approved protection classification in compliance with
locally applicable dust protection regulations.
Electrical safety
▶ Before beginning work, check the working area (e.g. using a metal
detector) to ensure that no concealed electric cables or gas and
water pipes are present. External metal parts of the power tool may
become live, for example, when an electric cable is damaged accidentally.
This presents a serious risk of electric shock.
Workplace
▶ The work you are doing may cause flying fragments. Wear eye protection,
protective gloves and, if you are not using a dust removal system,
wear light respiratory protection. Flying fragments present a risk of
injury to the eyes and body.
Personal safety
▶ The user and any other persons in the vicinity must wear suitable
eye protection, a hard hat, ear protection, protective gloves and
breathing protection while the power tool is in use.
Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage
and use of Li-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
There is a risk of explosion.
▶ Do not disassemble, squash or incinerate batteries and do not subject
them to temperatures over 80°C (176°F). This presents a risk of fire,
explosion or injury through contact with caustic substances.
▶ Never continue to use or attempt to charge damaged batteries, e.g.
batteries with cracks, broken parts, bent or pushed-in / pulled-out
contacts).
▶ If the battery is too hot to touch it may be defective. In this case,
place the power tool in a non-flammable location, well away from
flammable materials, where it can be kept under observation and
allowed to cool down. Contact Hilti Service after the battery has
cooled down.
3 Description
3.1 Parts of the tool and operating controls
7/16" hex. socket with locking
@
sleeve
Forward / reverse selector
;
switch with safety lock
6
Printed: 20.05.2015 | Doc-Nr: PUB / 5230969 / 000 / 00
1
Control switch
=
Light to illuminate the work
%
area
Belt hook (optional)
&