Hilti SID 8-A18 Manual De Instrucciones Original página 14

Status
1 LED blinks, the power tool is not
ready for use.
4 LEDs blink, the power tool is not
ready for use.
Note
Indication of the charge status is not possible while the power tool is
in operation or immediately after operation. If the battery charge status
LEDs flash, please refer to the information given in the Troubleshooting
section.
4 Technical data
4.1 Impact screwdriver
Rated voltage
Weight in accordance with EPTA-Procedure
01/2003
Rated speed under no load
Torque
4.2 Battery
Rated voltage
Capacity
Weight
Rated voltage
Capacity
Weight
5 Operation
Charging the battery
Note
Make sure that the outer surfaces of the battery are clean and
dry before inserting the battery in an approved battery charger.
Read the operating instructions for the charger for further infor-
mation about the charging procedure.
8
Printed: 20.05.2015 | Doc-Nr: PUB / 5230969 / 000 / 00
Meaning
• The battery has overheated.
• The power tool is overloaded or
has overheated.
B 18/1.6 B 18/2.6
Li­Ion Li­Ion (02)
21.6 V 21.6 V
1.6 A⋅h 2.6 A⋅h
1.06 lb 1.06 lb
B 18/5.2 Li-Ion
21.6 V
5.2 A⋅h
1.72 lb
21.6 V
DC
6.8 lb
2,200 rpm
500 N⋅m
B 18/3.3 Li-
Ion
21.6 V
3.3 A⋅h
1.72 lb