Inserting The Sim Card; Connecting The Battery And Power Supply - Grundfos CIM 2 GSM Serie Instrucciones De Instalación Y Funcionamiento

Grundfos.bk Page 7 Tuesday, May 24, 2011 4:24 PM

3.5 Inserting the SIM card

Before inserting the SIM card into the CIM 2XX,
remove the PIN code, or set it to "4321".
Procedure
1. Insert the SIM card into a mobile phone.
2. Remove the PIN code from the SIM card, or set it
to "4321". See the manual of the mobile phone.
3. Insert the SIM card into the CIM 2XX. See fig. 3.
The slanted edge of the SIM card must
Note
point downwards. See fig. 3.
1
2
Fig. 3 Inserting the SIM card
Pos. Description
1 SIM card holder
2 SIM card
3.6 Connecting the battery and power
supply
Warning
The CIM 2XX must only be connected to
SELV or SELV-E circuits.
Warning
The safety precautions listed below
must be observed carefully as improper
handling of the lithium-ion battery may
result in injury or damage from
electrolyte leakage, heating ignition or
explosion.
These safety precautions must be observed:
• Only insert the approved Grundfos battery pack
(96881516).
• Never use this battery pack in other battery
chargers.
• Do not dismantle or modify the battery.
• Do not heat or incinerate the battery.
• Do not pierce, crush or cause mechanical
damage to the battery.
• Do not short-circuit the battery.
• Do not allow the battery to get wet or be
immersed in water.
• Do not strike or throw the battery.
• For long periods of storage, the storage
temperature should be below +45 °C.
The CIM 2XX GSM module is fitted with a lithium-ion
battery. It is secured by a velcro strap which absorbs
vibrations and makes it easier to replace the battery.
Connect the battery to the CIM 2XX as shown in
fig. 4.
If the battery is not connected, the user
will not receive any information in case
Note
of a power cut.
Fig. 4 Connecting the battery
The battery will only be charged if the
Note battery temperature is within 0 °C to
+45 °C.
Switch on the power supply. The CIM 2XX is
powered either by the Grundfos product in which it is
fitted or by discharging the battery.
The LED1 is flashing yellow (searching for GSM
network). When the connection to the GSM network
has been established, the LED1 will pulsate yellow
(GSM network active). See fig. 5.
The LED2 is permanently green (internal
communication between the CIM 2XX and the
Grundfos product is OK).
The CIM 2XX is now ready for initialisation.
See section 2. Applications.
7