Billiger 1870 Manual De Instrucciones página 11

· Never use the appliance where aerosol (spray) products are being used or where oxygen is
released.
· To prevent injuries, never use the appliance if the blade set is damaged.
· Do not use disposable batteries. Rechargeable batteries should only be replaced at authorized
Service Centres.
· Before the appliance is used for the first time, it should be charged for approx.
2.5 hours.
· The appliance is safety insulated and radio screened. It meets the requirements of EU Directive
2004/108/EC regarding electromagnetic compatibility and EC Low Voltage Directive 2006/95/
EC.
Exhausted batteries/rechargeable batteries should not be disposed of in household
waste. Dispose of them in completely discharged state in accordance with legal
regulations.
Mains operation
· Connect the appliance plug on the plug-in transformer to the appliance socket (Fig. 1ⓐ).
· Connect the plug-in transformer to the mains power supply (Fig. 1ⓑ).
· Switch on the appliance using the on/off switch (Fig. 2ⓐ) and, after use, switch it off again
(Fig. 2ⓑ).
· Note: If the appliance does not function in power supply operation when the battery is fully
discharged, switch it off and charge the battery for 5 minutes until the lowest segment of the
LCD charge indicator starts to flash. Switch the appliance on again and operate from the power
supply.
Charging the battery
· Connect the appliance plug on the plug-in transformer to the charging stand socket (Fig 3ⓐ).
The appliance can also be connected directly to the plug-in transformer for charging.
(Fig. 1ⓐ/ⓑ).
· Connect the plug-in transformer into the socket (Fig 3ⓑ).
· Switch off the appliance using the on/off switch (Fig. 2ⓑ).
· Place appliance in the charging stand or connect directly to the plug-in transformer. A signal will
sound and the charging process begins.
· According to the charge status, the corresponding segment of the battery power indicator blinks
during the charging process. Once the battery is fully charged, all segments of the battery power
indicator will remain lit continuously. After the device has been removed from the charging
stand, the display goes out after approx. 30 seconds. (power saving mode)
· Recommendation: To assure the precision of the battery power indicator, the battery should
not be recharged until all segments of the battery power indicator have gone out during battery
operation.
· Once all segments of the battery power indicator have gone out, the appliance still has around
20% remaining capacity.
· It should take around 2½ hours for the appliance to charge to full capacity.
· Once the battery is fully charged, a signal will sound.
Battery operation
· Switch on the appliance using the on/off switch (Fig. 2ⓐ) and, after use, switch it off again
(Fig. 2ⓑ).
· After the appliance has been switched off, the display goes out about 30 seconds later. (power
saving mode)
ENGLISH
de
en
fr
it
es
pt
nl
sv
no
fi
tr
pl
cs
sk
hu
sl
ro
bg
ru
uk
el
ar
11