Billiger 1870 Manual De Instrucciones página 13

Idiomas disponibles

Should the sensor system recognize such a situation, an acoustic signal sounds and the LCD dis-

play blinks for 2 minutes after the hair clipper has been switched off. This signal and blinking can

be cancelled by briefly switching the hair clipper on and then off again. Before the hair clipper is

again used, you are urgently advised to clean both the hair clipper and the blade set and oil the

blade set. Please do so as follows (if these instructions are not observed, the hair clipper can suf-

fer damage and stop working. In such cases the warranty claim expires):

· Switch off the appliance using the on/off switch (Fig. 2ⓑ).

· Remove the attachment comb and the blade set and use the cleaning brush to clean the open-

ing of the housing and the blade set. (Fig. 7).

· Oil the blade set (Fig. 8).

Changing the blade set

· Switch off the appliance using the on/off switch (Fig. 2ⓑ).

· The blade set can be removed by sliding it away from the housing in the direction of the arrow

(Fig. 6ⓐ).

· Replace the blade set by hooking it into the housing and pressing it down until it clicks into posi-

tion in the housing (Fig. 6ⓑ).

Disposal in EU countries

Do not dispose of the appliance with domestic refuse. As part of the EU Directive govern-

ing the disposal of electrical and electronic equipment, the appliance is accepted free of

charge by local waste collection points or recycling centres. Discharge batteries prior to

disposal! Correct disposal will ensure environmental protection and prevent any poten-

tially harmful impacts on people and the environment.

Disposal in non-EU countries

· Please dispose of the appliance at the end of its service life in an environmentally friendly

manner.

· Disconnect the plug-in transformer from the mains power supply and switch on the appliance to

discharge the battery completely.

· Remove the blade set (Fig. 6ⓐ) and use a screwdriver to remove the screws in the opening of

the housing (Fig. 9). Pull the housing parts apart and remove the entire drive with the PCB

(Fig. 10).

· Pull battery off circuit board. If necessary, use a screwdriver to pry them off (Fig. 11).

· Take the batteries to an appropriate collection point.

· Once the batteries have been removed, the appliance may no longer be connected to the

mains!

ENGLISH