Residual Risks; Assembling Instructions; Assembling The Handle Bar; Mounting And Emptying The Collection Bag - Deltafox DG-ESA 1332 Traducción Del Manual De Instrucciones Original

GB

Residual Risks

There will always be residual ris-
ks even if you operate this electri-
cal tool according to the instruc-
tions. The following hazards may
occur in connection with the type
and design of this electric tool:
a) Cutting injuries
b) Hearing damage if suitable
ear protection is not worn.
c) Health injuries resulting from
the effect of vibration on the
hands and arms in the event
that the device is used over a
longer period of time or is not
used and maintained properly.
Warning! During operation,
this power tool produces
an electromagnetic field.
Under certain circumstan-
ces, this field may negati-
vely affect active or passive
medical implants. In order
to reduce the danger of
serious or fatal injuries, we
recommend that individuals
who wear medical implants
should consult their doctor
and the manufacturer of
the implant before opera-
ting the machine.

Assembling instructions

Prior to any work on the implement
always disconnect the plug from
the power socket!
Ensure during assembly that the
power cable is not squeezed and
that it has sufficient play.
32
B

Assembling the handle bar

1. Attach the lower bar (6) to the ap-
pliance housing (8) and fasten it
using the two quick-release levers
and washers (7). The smooth side of
the washer should point towards the
quick-release lever; the grooved side
should point towards the device.
2. Screw both central bars (5) with the
screws, quick-release levers and
washers (4) to the lower bar (6). The
smooth side of the washer should
point towards the quick-release lever;
the grooved side should point towards
the device.
3. Hang the strain relief (15) into the up-
per handlebar (3).
4. Screw the upper handlebar (3) with
the screws, quick-release levers and
washers (4) to both central bars (5) to
fasten. The smooth side of the washer
should point towards the quick-re-
lease lever; the grooved side should
point towards the device.
5. Fasten the machine cable (14) to the bar
using the machine cable terminals (13).
Mounting and emptying
C
the collection bag
WARNING: Never operate the
implement without the impact
protector. Danger of Injury!
The collection bag is recommended
for operation with the air roller
( A 16)!
1. Pull the collection bag (11) over the
rods.
2. Put the plastic straps of the collection
bag over the collection bag (11) rods
and clip into the plastic straps.