Cleaning/Maintenance; General Cleaning And Maintenance Work; Exchanging The Cylinder; Storage - Deltafox DG-ESA 1332 Traducción Del Manual De Instrucciones Original

• Lift the implement to transport it over
steps and sensitive surfaces (e.g.
tiles). Use the handle (

Cleaning/maintenance

Work that has not been de-
scribed in these Instructions
must be carried out by a servic-
ing agency authorised by us.
Only use original parts.
Wear gloves when handling the
cylinder.
Prior to all maintenance and clean-
ing work always switch off the imple-
ment, disconnect the plug from the
power socket and wait until the cylin-
der is standing still. Warning! Risk of
injury by dangerous moving parts!
General cleaning and
maintenance work
Do not jet water onto the imple-
ment and do not clean it under
flowing water. This would result in
the danger of an electric shock and
the implement could be damaged.
• When work has finished remove plant
residues adhering to the wheels, inside
the ventilation opening, the grass ejec-
tor opening and the cylinder. Do not use
hard or pointed objects for this purpose
as they could damage the implement.
• Completely empty the collection bag.
• Always keep the implement clean. Do
not use cleaning agents or solvents.
We cannot be held liable for damage
caused by our implements if they were
improperly repaired, if non-original parts
9).
A
have been used or if they were used not in
keeping with their intended purpose.
E

Exchanging the cylinder

Switch off the implement, discon-
nect the mains plug and wait until
the cylinder is standing still.
Wear gloves when handling the
cylinder.
1. Turn the implement over.
2. Loosen the wing screw (19) and pull the
bearing support (21) upwards.
3. Lift the roller (
pull the shaft out of the hexagon re-
ceptacle (20).
4. Insert the new cylinder (
reversing the sequence.

Storage

To save space when stored, the handlebar
can be folded down after releasing the
tightening levers.
Ensure that the cables are not
squeezed.
• Store the implement in a dry place well
out of reach of children.
• Allow the motor to cool down before
placing the implement in a closed room.
• Do not wrap nylon sacks around the
implement as this could result in the
formation of moisture.
A
16/17) diagonally and
A
16/17) by
GB
35