Assembly; Operation; Operating Times - MTD 350 G Manual Del Usuario

z Always wait for the cutting tool is stop.
z Before examining or cleaning the tool or be-
fore removing the safety device or the cord
spool, switch off and disconnect the trimmer
from the mains. Only use original cord spools
and note the installation instructions!
z The cutting knife should not be cleaned under
running water or under high-pressure.
z Faults shall only be repaired by appointed
service centres or by the manufacturer.

Assembly

Attach the protective cover
1. Place the protective cover on the lawn trimmer
A
.
2. Attach the protective cover with the fastener
B
3 screws .
Before starting the trimmer, remove the
cut protector on the thread measurer
Assembly of the lawn trimmer
3
Note:
The lawn trimmer can be used for free cut-
L
ting and edge cutting
mation, see the Chapter "Working Position"
Page 10).
z Plug the upper portion of the lawn trimmer into
the lower portion. The connection snaps audi-
D E
bly .

Operation

Operating times

z Please check noise abatement regulations
prevailing in your country.
Set the grip height (Typ B)
1. Loosen the hand wheel
2. Pull the telescoping section until the ideal grip
height is achieved
3. Turn the hand wheel
G
N
(for more infor-
H
.
H
.
H
.
z Make sure all air holes are free of dirt.
z Do not store the unit within reach of children.
Disposal
Do not dispose of electrical equip-
ment in domestic waste. Recycle
equipment, accessories and packag-
ing in an environment-friendly man-
ner.
3
Disassembly of the lawn trimmer
In order to be able to change the working
position, one can loosen the upper and low-
er sections of the lawn trimmer.
z Typ A: Press both locks of the upper sec-
tion together
apart
z Typ B: Press the locks for the telescop-
C
.
ing section in the direction of the arrows
G
Insert power cable into cable holder
The power cable holder in the guide grip prevents
accidental disconnection of the extension cable
J K
.
F
and pull both sections
F
.
and pull both sections apart
G
.
9