LUND Rampage 88460 Instrucciones De Instalación

07-18 Jeep Wrangler JK &
JK Unlimited
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at
Contents
NOTE: Actual product may vary from illustration.
(2) Tail Light
Guards
1
Remove the 4 factory screws secureing the lens
to the taillight.
Note: the (2) screws closest to the tailgate also
secure the tail light assembly to the vehicle. Take
care the assembly does not fall after removing
the screws.
See Figure 1.
2
Using the provided Large Diameter Screws,
attach the Tail Light Guard to the Tail Light at the
two outer screw locations.
Then install the Small Diameter Screws through
the light guard, through the tail light and into the
pre-existing holes in the body.
THe outer edge of the tail light has clips that hook
to the sheet metal. Make sure they are properly
engaged before installing the inner screws.
See Figure 2.
Congratulations!
You have purchased one of the many quality Rampage branded products offered by Lund
International. We take the utmost pride in our products and want you to enjoy years of satisfaction
from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Installation Instructions
Euro Tail Light Guards
(4) Large
(4) Small
Diameter
Diameter
Screws
Screws
800-328-2409 • Visit us at Rampageproducts.com
© 2018 Lund Motion Products, Inc. All rights reserved.
Rampage Products™ is a trademark of Lund Motion Products, Inc.
Page 1 of 1
Tools Required
Figure 1
Remove
Figure 2
The material that your product is made from can
be recycled. Please also consider recycling the
packaging that your product came in.
IS-LG-88
Part Number
88460 & 88660
.
1-800-328-2409
Philips Head Screwdriver