Schlage Control FE410F Instrucciones Para La Instalación página 4

3b Install the lever assembly on the outside of the door.
L The lever will be installed later.
Make sure the notch
faces the latch. See
step 4a.
3c Secure the inside assembly with the two bottom screws.
3d Move the handing screw and cam stop to the
appropriate position, if necessary.
L See Determine the Handing on page 1 to determine the
hand of your door.
If the handing screw is not in the correct position, locking and
unlocking could be reversed, resulting in an unsecured residence.
Handing screw
Left hand
position
Actual Size (2)
CAUTION
OR
and cam stop
4
Apply power to the lock.
4a Connect the cable to the inside assembly.
The connector fits only one way. DO NOT FORCE!
4b Install the batteries.
5
Install the inside cover.
5a Place the inside cover on the door.
Right hand
position
CAUTION
Align the slot with
the tailpiece.
Thumbturn should
be pointed towards
hinges, with longer
side on top.
Guide the hole onto
the spindle.
Red wire