Setting Up And Aligning The Scale - Seca 677 Manual De Instrucciones Y Garantía

– Connect the mains power unit to the
scale.
– Connect the mains power unit to the
socket.

4. Setting up and aligning the scale

– Place the scale on a level surface.
– Set up the handrail as described in the
previous section.
– Undo the locknuts using the four foot
screws (1).
– Align the scale by undoing the foot
screws. The air bubble in the spirit level
must be right in the centre of the
circle (2).
– Then re-tighten the locknuts (3).
– Fold down the ramps required.
– Ensure that only the feet of the scale are
in contact with the floor. The scale may
not be in contact at any other point.
Important!
The alignment of the base of the scale must be checked and corrected if neces-
sary every time the location of the scale is changed.
Model 677
3 .
1 .
2 .
spirit level
Libelle
23
GB