Shure Performance Gear Manual Del Usuario página 21

System and Receiver Specifications
System
RF Carrier Frequency Range*
Operating Range Under Typical Conditions
Audio Frequency Response
Image Rejection
Spurious Rejection
System Distortion (ref. + 45 kHz deviation, 1 kHz modulation)
System Distortion (ref. + 15 kHz deviation, 1 kHz modulation)
Signal/Noise Ratio
Sensitivity
Maximum Recommended Input Level
(UT1 - attenuation switch at -20 dB - gain at minimum)
Minimum Recommended Input Level
(UT1 - attenuation switch at 0 dB - gain at maximum)
Operating Temperature Range**
Battery Life
Receiver
Maximum Output Levels
Nominal Output Levels
Output Configuration
Actual Impedance
Connector Pin Assignments
Dimensions
Weight
Power Requirements
Power Supply
Voltage/Current/Phantom Power Protection
*Available frequencies depend on applicable regulations in country where system is used
**Battery characteristics may limit this range.
T4A: Approved under the Declaration of Conformity (DoC) provision of FCC Part 15. Certified by IC in Canada under RSS-123 (IC: 616A-T4A).
UT4A: Approved under the Declaration of Conformity provision of FCC Part 15. Certified by IC in Canada under RSS-123 (IC: 616A-UT4A).
T4A and UT4A Receivers meet the essential requirements of the European R&TTE Directive 99/5/EC and are eligible to carry the CE marking.
Power supply meets the following safety standards:
PS20 Power Supply: UL 1310, CAN/CSA 22.2 No. 223
PS20E Power Supply: IEC/EN60065, 6th Edition: 1998
PS20J Power Supply: Meets DENTORI 91–49851
PS20UK Power Supply: IEC/EN60065, 6th Edition: 1998
Note: PS20E and PS20UK power supplies meet the requirements of European Low Voltage Directive 73/23/EEC.
VHF
169.445 to 240.000 MHz
100 m (328 ft)
50 to 15,000 Hz, ±3 dB
> 60 dB typical
> 60 dB typical
0.1% THD typical
100 dB
-109 dBm for 12 dB SINAD
typical
+3 dBV
-80 dBV
-18° to 57° C (0° to 135° F)
18 hours with 9 V alkaline
battery
T4A (VHF)
3-Pin XLR -10 dBV
1/4" phone plug +5 dBV
3-Pin XLR -30 dBV
1/4" phone plug -8 dBV
3-Pin XLR Active Balanced
1/4" phone plug Unbalanced
3-Pin XLR 3.3 kΩ
1/4" phone plug 3.3 kΩ
3-Pin XLR Pin 1: ground • Pin 2: hot • Pin 3: cold
1/4" phone plug Tip: hot • Sleeve: ground
197.1 mm W x 41.9 mm H x 153.2 mm D (7.76 W x 1.65 H
x 6.03 D)
470 g (16.04 oz.)
12-18 Vdc nominal, 200mA
120 V or 230V ac adaptor with 2.1 mm female plug
Yes
21
UHF
596 to 865 MHz
100 m (328 ft)
20 to 16,000 Hz, ±3 dB
> 75 dB typical
> 75 dB typical
0.1% THD typical
100 dB
-110 dBm for 12 dB SINAD
typical
+32 dBV
-80 dBV
-29° to 74° C (-20° to 165° F)
12 hours with 9 V alkaline
battery
UT4A (UHF)
Line: +10 dBV
Mic: -10 dBV
+4 dBV
Line: -26 dBV
Mic: -46 dBV
-32 dBV
Active Balanced
Unbalanced
Line: 50Ω
Mic: 2.5 kΩ
1 kΩ