Information About The Documentation; About This Documentation; Explanation Of Symbols Used; Symbols In The Documentation - Hilti HDM 330 Manual Original

1 Information about the documentation

1.1 About this documentation

• Read this documentation before initial operation or use. This is a prerequisite for safe, trouble-free
handling and use of the product.
• Observe the safety instructions and warnings in this documentation and on the product.
• Always keep the operating instructions with the product and make sure that the operating instructions
are with the product when it is given to other persons.

1.2 Explanation of symbols used

1.2.1 Warnings
Warnings alert persons to hazards that may occur when handling or using the product. The following signal
words are used in combination with a symbol:
DANGER! Draws attention to an imminent hazard that will lead to serious personal injury or
fatality.
WARNING! Draws attention to a potential hazard that could lead to serious personal injury or
fatality.
CAUTION! Draws attention to a potentially dangerous situation that could lead to minor personal
injury or material damage.

1.2.2 Symbols in the documentation

The following symbols are used in this document:
Read the operating instructions before use
Instructions for use and other useful information
1.2.3 Symbols in the illustrations
The following symbols are used in illustrations:
These numbers refer to the corresponding illustrations found at the beginning of these operating
instructions.
The numbering reflects the sequence of operations shown in the illustrations and may deviate
from the steps described in the text.
Item reference numbers are used in the overview illustration and refer to the numbers used in
the key in the product overview section.
This symbol is intended to draw special attention to certain points when handling the product.
1.3 Symbols in the documentation
1.3.1 Symbols
The following symbols are used in this document:
National waste-materials management system
Wear protective clothing when working with the tool.
1.3.2 Explanation of symbols used
The following symbols are used on the product:
Wear protective goggles while working with the tool.
Wear protective gloves when working with the tool.
Printed: 20.03.2017 | Doc-Nr: PUB / 5069968 / 000 / 06

English

7