Uline SANITAIRE Manual Del Usuario página 4

6. Lift up on the brush roll, disconnect other end of belt
from motor pulley and remove the worn belt.
(See Figure 13)
Figure 13
7. Place new belt around the brush roll. Align brush roll
pulley with the belt guide in the base. (See Figure 14)
Figure 14
Belt Guide
8. Make sure rubber end caps are secure in place on
the sides of the brush roll. Align end caps with slots in
the cleaner base so that the two arrows are pointing
down. Push the brush roll down into the base.
(See Figure 15)
Figure 15
PAGE 4 OF 16
USE AND MAINTENANCE CONTINUED
9. Place the lower side of the belt into the belt guide
and pull to stretch the belt around the left side of
the motor pulley. (With front of vacuum facing you)
Rotate the brush roll two times to the center of the
belt and align it into the groove. (See Figure 16)
Figure 16
10. Align three slots towards the front of the bottom plate
over the tabs on the front of the base. Make sure
front inserts are securely connected to the bottom
plate. Push the bottom plate down over the grooves
that are on the base. Secure the bottom plate with
the cam lock. (See Figure 17)
Figure 17
NOTE: Improper installation of the brush roll
or the brush roll belt could cause carpet or
cleaner damage.
0421 IH-2549