Troubleshooting - Galletti UTN Serie Instalación Uso Y Mantenimiento

9 CLEANING OF THE AIR FILTER
Cut voltage to the unit by turning the line switch to 0 (OFF).
- When using one of the MA/F or MA/FO filtering modules, access the equipment
through the inspection panel and remove the air filter as shown in FIGURE 12.
- Otherwise if the filter is inside the intake grid, remove the grid and carry out the
operations described below.
FIGURE 12:
-1- MA/F - MA/FO = Intake modules with filter
-2- The air filter, secured to the intake module by means of screws, is pulled out like
a drawer.
Clean the filter with lukewarm water or, for dry powders, with compressed air.
Reinsert the filter after having let it dry.
CLEANING OF THE HEAT EXCHANGER
It is advisable to check the condition of the heat exchanger before the onset of the
summer season, checking that the fins are not clogged by impurities. To access the
heat exchanger, remove the delivery panel (whether it is the collar or rectangular flange
type) and the condensate tank. Upon having accessed the heat exchanger, clean
with compressed air or low pressure steam, without damaging the fins of the heat
exchanger.
Before operating it in the summer, check that the condensate discharges regularly.
Adequate and regular maintenance means energy conservation and cost
10

TROUBLESHOOTING

If the equipment does not work efficiently, perform the following checks, outlined
in the table below, before requesting technical service.
If the problem cannot be solved, contact your nearest dealer or servicing center.
Problem Cause
The unit does not work 1 No current
2 The automatic circuit
breaker tripped
3 The start switch is set to 0.
The unit does not heat or cool 1 The air filter is dirty or
enough clogged
2 There is an obstacle near the
air intake or outlet
3 Air is present inside the heat
exchanger
4 Windows and/or doors are
open
5 The minimum operating
speed has been selected
Water is 'leaking' from the unit 1 The equipment is not
installed with the correct
inclination
2 The condensate discharge is
clogged
È severamente vietata la riproduzione anche parziale di questo manuale / All copying, even partial, of this manual is strictly forbidden
saving.
Solution
1 Supply current
2 Request technical service
3 Start the machine by setting
the switch to I
1 Clean the air filter
2 Remove the obstacle
3 Request installer intervention
4 Shut doors and/or windows
5 Select the average or
maximum speed
1 Request installer intervention
2 Request installer intervention
7
GB
UT66000182 - 03