Troubleshooting - Galletti FLAT Manual Del Usuario

FLAT
9

TROUBLESHOOTING

If the unit is not working properly, before calling a service engineer carry out the checks indicated in the table below.
If the problem cannot be solved, contact your dealer or the nearest service centre.
PROBLEM
The unit fails to work
The unit provides insufficient cooling or heating
The unit "leaks" water.
È severamente vietata la riproduzione anche parziale di questo manuale / All copying, even partial, of this manual is strictly forbidden
CAUSE
1. no power supply
2. the automatic safety cut-out has tripped
3. the on/off switch is on 0.
4. FLAP closed
1. the air filter is dirty or clogged
2. the heat exchanger is dirty
3. an obstacle is obstructing the air intake or
outlet
4. air is trapped inside the heat exchanger
5. there are open windows and/or doors
6. the low speed has been selected
1. the unit has not been installed with the
correct inclination
2. the drainage outlet is clogged
9
REMEDY
1. Restore the power supply
2. Call a service centre for assistance
3. Start the unit by moving the switch to I
4. Open the FLAP
1. Clean the air filter
2. Call the installer for assistance
3. Remove the obstacle
4. Call the installer for assistance
5. Close windows and/or doors
6. Select medium or high speed
1. Call the installer for assistance
2. Call the installer for assistance
GB
FC66001820- 00