Axxess AX-MB1 Instrucciones De Instalación página 3

Installing the AX-MB1
With the key in the off position:
• Connect the LD-AX-XSVI-MB1 or LD-AX-XSVI-MB2 harness into the interface,
and then to the wiring harness in the vehicle.
®
AX-MB1
Initializing the AX-MB1
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an ASWC-1 connect it after you initialize
and test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
Note: If using the ASWC-1, connect it after you initialize the AX-MB1, with the
key in the off position.
3