Default Parameters; Programming The Clock; Configuring The Display - Xylem Lowara SM30 Manual De Instalación, Funcionamiento Y Mantenimiento

6 REL.OUT6 CONFIG

6.2.14 DEFAULT PARAMETERS

Phase Display
0 DEFAULT
1 DEFAULT
PARAMETER

6.2.15 PROGRAMMING THE CLOCK

Phase Display
0 REAL TIME CLOCK
1 SET DATE
2 SET HOUR

6.2.16 CONFIGURING THE DISPLAY

Phase Display
0 DISPLAY
1 AI1 DISPLAY
2 AI2 DISPLAY
3 HOUR/DATE DISPL. The display shows the value of the
4 BARGRAPH
6.2.17 SOFTWARE
Phase Display
0 SOFTWARE
1 VERSION
relay of the RILS6 optional board
Allows you to configure the OUT_6
relay of the RILS6 optional board
Comment
Loads all the default parameters
(factory setting)
Comment
Setting the date
Setting the hour and the minutes
Comment
The display shows the value of AI1
The display shows the value of AI2
date and time
Enables display of the indicating bar on
input selected as feedback.
Available only on systems with
sensors.
Comment
Only reading of program loaded and
release number
configuration 1
See POWER
configuration 1 ON
Field Default
YES
NO
Field Default
Day
Month
Year
Hour +
Minutes
Field Default
YES YES
NO
YES YES
NO
YES NO
NO
YES NO
NO
Field Default
BSETF3
REL .01
en
47