Unpacking Steps; Mounting The Switch; Installing In A Rack - Dell PowerConnect 8024 Guia De Inicio Rapido

Unpacking Steps

NOTE:
Before unpacking the switch, inspect the container and immediately report any evidence
of damage.
1
Place the container on a clean, flat surface and cut all straps securing the container.
2
Open the container or remove the container top.
3
Carefully remove the switch from the container and place it on a secure and clean surface.
4
Remove all packing material.
5
Inspect the product and accessories for damage.

Mounting the Switch

CAUTION:
information for other switches that connect to or support the switch.
The two AC power connectors are on the back panel of the switch.

Installing in a Rack

CAUTION:
to a wall.
CAUTION:
from the underside of the switch, if they have been attached.
CAUTION:
1
Place the supplied rack-mounting bracket on one side of the switch, ensuring that the
mounting holes on the switch line up to the mounting holes in the rack-mounting bracket.
Figure 1 illustrates where to mount the brackets.
Figure 1. Attaching the Brackets
6
Getting Started Guide
Read the safety information in the Product Information Guide as well as the safety
Do not use rack mounting kits to suspend the switch from under a table or desk, or attach it
Disconnect all cables from the switch before continuing. Remove all self-adhesive pads
When mounting multiple switches into a rack, mount the switches from the bottom up.